A furnace that won't ignite, short-cycles, or keeps tripping its limit switch needs more than a reset in Kennebunkport winters. A CO check happens on every call, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. We test with real equipment, not parts-cannon guessing.
Safety and accuracy on every heating call.
A combustion analyzer reading for dangerous CO levels is part of every visit, not optional.
No-heat calls in Kennebunkport get priority routing over routine work during cold snaps when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Both fuel types get the same trained tech, no exceptions.
The most common furnace failure points.
Cracked ignitors and carbon-fouled sensors cause a large share of no-heat calls, usually a same-visit fix.
We test actual response and pressure output rather than replacing an expensive part on a hunch before we recommend replacing it.
We inspect carefully with proper equipment rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older Kennebunkport furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Tell us what the furnace is doing and we'll get someone moving.
A stocked truck arrives ready to diagnose and often repair same visit.
Safety and diagnostic checks come first, then a flat-rate quote.
We re-check CO before signing off, backed by warranty.
Recent reviews from winter heating calls.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
We always confirm with a proper reading before quoting.
Yes — it can let combustion gases into breathing air, we won't run a confirmed-cracked unit, taken seriously.
A CO check is standard on every call, no upcharge.
We still service these older systems.
No-heat calls get priority routing, usually same-day even during high demand.
Uncommon parts might mean a follow-up visit to finish the repair.
Our furnace repair coverage spans Kennebunkport and nearby Kennebunkport, ME zips below — call to confirm.
Confirm Coverage
